Burnishing The Brake - Toro Z Master G3 3000 Series Service Manual

HYDRAULIC SYSTEM

Burnishing the Brake

1. Raise the rear of the machine and support it with 2
jack stands placed under the right and left tie down
loops (Fig. 328).
5
2. Remove the two rear wheels (Fig. 329).
5-20
Fig. 328 PICT-8548
Fig. 329 PICT-8550a
3. Clear the area of any flammable material before
starting the burnishing process.
4. Rotate the drive wheel release valve to the
"operating" position (Fig. 330).
A
B
A. Vertical: "released"
to push the machine
5. Engage the parking brake.
6. Install a 1/2" x 6" (approximately) rod or bolt through
the 2" height -of-cut hole (Fig. 331).
Toro Z Master G3 3000/5000/6000 Series Service Manual
Fig. 330 fig. 36 G008957
B. Horizontal: "operating"
to drive the machine
Fig. 331 G3CheckValveParkBrake_a