Toro Z Master G3 3000 Series Service Manual page 46

5. Route the brake cable into the retainers on the
cradle following the routing diagram (Fig. 091).
B
A
Fig. 091
A. Right side brake
assembly
B. Cradle
6. Install the left hand brake cable retainer into the
cradle so that the retainer tab is installed in the slot
on the cradle (Fig. 092).
Fig. 092
Toro Z Master G3 3000/5000/6000 Series Service Manual
C
D
D
cables routing #4
C. Left side brake
assembly
D. Retainer (5)
PICT-9027a
7. Slide the brake cable behind the wheel hub and slide
the threaded end of the brake cable through the
trunnion located in the brake caliper (Fig. 093).
Fig. 093
8. Install the brake cable snap fitting into the slotted
bracket (Fig. 094).
Fig. 094
CHASSIS
PICT-9063a
PICT-9065a
3-25
3