Park Brake Handle Assembly Replacement - Toro Z MASTER 2000 Series Service Manual

Choke Control Assembly Installation (continued)

Park Brake Handle Assembly Replacement

Park Brake Handle Assembly Removal
2000 Series Z MASTER® Service Manual
3438-778 Rev A
2. Thread the jam nut over the choke cable up to the control panel assembly.
g336058
3. Attach the choke cable assembly to the control panel with the jam nut.
4. Install the control panel assembly into the console.
5. Move the choke control lever to the open position (down).
6. Place the Z-bend of the choke cable in the choke plate on the engine in
the position previously noted.
7. Place the cable under the cable clamp.
8. Ensure that the choke control lever is pressed down fully and tighten the
cable clamp.
9. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
1. Park the machine on a level surface and disengage the PTO. Stop the
engine, wait for all moving parts to stop, and remove the key.
2. Disconnect the battery by removing the negative cable first, then the positive
cable from the battery.
3. Release the parking brake (park brake handle down).
4. Remove the left side console.
5. Remove the locking cotter pin securing the upper brake linkage to the park
brake lever.
Note: To completely remove the upper brake linkage, remove the locking
cotter pin from the brake shaft and remove the clevis pin. The linkage
can now be removed from the frame slot for inspection, adjustment, or
replacement.
Figure 42
Left Console Replacement (page 5–11)
Page 5–23 Chassis: Service and Repairs