Toro Z Master G3 3000 Series Service Manual page 148

10. Remove the spacer (Fig. 411).
Fig. 411
11. Turn the spindle housing over and remove the oil
seal from the bottom of the spindle housing (Fig.
412). Note the orientation of the lower oil seal. The
open end of the seal faces outwards to help relieve
pressure from over-greasing the spindle assembly.
Fig. 412
Toro Z Master G3 3000/5000/6000 Series Service Manual
12. Remove the bearing from the bottom of the spindle
(Fig. 413).
DSCN-2677a
13. Using a hammer and a driver with a square edge,
drive both the top and bottom bearing races out of
the spindle housing (Fig. 414).
DSCN-2679a
MOWER DECKS
Fig. 413
Fig. 414
DSCN-2680a
6
DSCN-2681a
6-11