Adjusting The Motion Control Neutral Lock Pivot; Adjusting The Control Handle Position - Toro Z Master G3 3000 Series Service Manual

Adjusting the Motion Control Neutral
Lock Pivot
Note: The flanged nut can be adjusted to obtain a
more desired motion control lever resistance
when moving it to the neutral lock position.
See Figure 188 for adjustment options.
Fig. 188
A. Flanged nut
1. Loosen the jam nut.
2. Tighten or loosen the flanged nut to the desired feel.
For more resistance, tighten the flange nut. For less
resistance, loosen the flange nut.
3. Tighten jam nut.
Toro Z Master G3 3000/5000/6000 Series Service Manual
A
B
fig. 88 G008621
B. Jam nut
Adjusting the Control Handle
Position
Note: There are two height positions for the control
levers; high and low. Remove the bolts to
adjust the height for the operator.
1. Disengage the PTO, move the motion control levers
to the neutral locked position, and set the parking
brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Loosen the bolts and flange nuts installed (Fig. 189).
A
B
C
Fig. 189
A. Bolt
B. Handle
CHASSIS
D
fig. 84 G009040
C. Control lever
D. Nut
3-53
3