Motion Control Damper Installation; Adjusting The Motion Control Damper - Toro Z Master G3 3000 Series Service Manual

CHASSIS

Motion Control Damper Installation

Motion Control Damper (Fig. 185)
3
A. Belleville washer
1. Install the damper with ball joint end that has the
Belleville washer into the frame. Torque the lock nut
to 200 in-lbs. (16.7 ft-lbs. or 22.6 Nm) (Fig. 186).
2. Install the other end of the damper to the motion
control assembly, normally in the center hole and
tighten the lock nut to 200 in-lbs. (16.7 ft-lbs. or 22.6
Nm). For adjustments, see "Adjusting the Motion
Control Damper" on page 3-52.
3-52
A
Fig. 185
DSCN-4452a
Fig. 186
DSCN-4450a

Adjusting the Motion Control Damper

Note: The top damper mounting bolt can be adjust­
ed to obtain a more desired motion control
lever resistance. See Figure 187 for mounting
options.
A. Torque the lock nut to 200 in-lbs. (16.7 ft-lbs. or 22.6
Nm). Bolt must protrude past end of locknut after
torque.
B. Most resistance (firmest feel)
C. Damper
D. Medium resistance (medium feel)
E. Least resistance (softest feel)
Toro Z Master G3 3000/5000/6000 Series Service Manual
A B C
E
D
Fig. 187 fig. 87 G008620