Toro Z Master G3 3000 Series Service Manual page 122

19. Position a floor jack under the cradle on the side of
the machine being serviced. Raise the floor jack to
contact the cradle (Fig. 350).
Fig. 350
20. On the side of the machine being serviced, remove
the two bolts securing the UHT transmission to the
frame (Fig. 351).
Fig. 351
Toro Z Master G3 3000/5000/6000 Series Service Manual
HYDRAULIC SYSTEM
21. Lower the UHT transmission/cradle assembly from
the frame by lowering the floor jack. Take care that
the UHT transmission fan clears the frame.
Note: Ensure the control arm shaft clears the
frame, and the control arm linkage doesn't
get caught between the frame and the UHT
transmission, as it is being lowered.
22. Remove the two nuts from the carriage bolts
securing the UHT transmission to the cradle (Fig.
352).
DSCN-4522a
23. Remove the UHT transmission from the cradle (Fig.
353).
Caution: The UHT weighs approximately 80 lbs.
(36.29kg).
DSCN-4528a
Fig. 352 DSCN-4529a
Fig. 353 DSCN-4533
5
5-27