Brake Caliper Replacement; Brake Caliper Removal - Toro Z Master G3 3000 Series Service Manual

14. Plug the wire harness to the park brake switch (Fig.
169).
Fig. 169
15. Install the two screws retaining the right hand
motion-control cover assembly to the frame (Fig.
170).
Fig. 170
16. Install the rear tires and torque lug nuts between
103.5 – 126.5 ft-lbs. (140.5 – 171.5 Nm).
17. Remove the jack stands and lower the unit.
Toro Z Master G3 3000/5000/6000 Series Service Manual

Brake Caliper Replacement

Brake Caliper Removal

Note: The left side is being removed; use the same
instructions for right side removal.
1. Raise the rear end of the unit and install jack stands
under the tie down loop on the frame. Remove the
wheel.
2. Disengage the park brake lever.
3. Remove the e-ring, washer, and brake pin from the
L-Bracket (Fig. 171).
DSCN-2617a
DSCN-2614a
CHASSIS
Fig. 171
DSCN-4314a
3
3-47