Toro Z Master G3 3000 Series Service Manual page 99

HYDRAULIC SYSTEM
14. On the side of the machine being serviced, remove
the bolt and washer securing the hydro control arm
to the hydro drive control shaft (Fig. 273).
15. On the side of the machine being serviced, pry the
control arm off the square tapered shaft (Fig. 274).
5
Note: Be careful to not damage the trunnion shaft
seal.
5-4
Fig. 273 PICT-8563
Fig. 274 PICT-8566
16. On the side of the machine being serviced, remove
the cotter pin securing the castle nut to the wheel
hub (Fig. 275).
17. On the side of the machine being serviced, remove
the castle nut from the wheel hub (Fig. 276).
Toro Z Master G3 3000/5000/6000 Series Service Manual
Fig. 275 PICT-8578
Fig. 276 PICT-8580