Park Brake Cable Replacement (2011 & Prior); Left Park Brake Cable Removal (2011 & Prior) - Toro Z Master G3 3000 Series Service Manual

Park Brake Cable Replacement (2011
& Prior)
Left Park Brake Cable Removal (2011 &
Prior)
1. Raise the rear end of the unit and install jack stands
under the tie down loops on the frame. Remove the
RH and LH wheels from the unit (Fig. 075).
Fig. 075
2. Disengage the park brake lever.
3. Remove the two nuts located on the end of park
brake cable (Fig. 076).
Fig. 076
Toro Z Master G3 3000/5000/6000 Series Service Manual
4. With needle nose pliers, squeeze the tabs on the
brake cable and pull the brake cable out of the slot in
the cable anchor (Fig. 077).
5. Slide the brake cable out of the cable anchor and out
towards the front (Fig. 078).
PICT-8962
PICT-9075a
CHASSIS
Fig. 077 PICT-8969a
Fig. 078 PICT-8970a
3
3-21