MOWER DECKS
16. Install the heavy washer and nut on the top of the
spindle shaft (Fig. 431).
Note: The cup side of the washer should be facing
down toward the pulley hub.
17. Torque the top nut to 100 - 120 ft-lbs. (135.58 -
162.7 Nm) (Fig. 432).
6
18. Grease the spindle assembly using a grease gun
with No. 2 grease.
6-16
Fig. 431
DSCN-2708a
Fig. 432
DSCN-2709a
Mower Spindle Replacement (2010
& Later Model G3, 3000/5000/6000
Series Units)
Mower Spindle Removal (2010 & Later
Model G3, 3000/5000/6000 Series Units)
Note: The following procedure applies to removing
any of the three mower spindles. This proce-
dure shows removing the right side spindle.
1. Park the machine on level surface, disengage the
PTO clutch, turn the ignition switch off and remove
the key.
2. Remove the negative battery cable from the battery.
3. Remove the RH mower deck belt cover (Fig. 433).
Toro Z Master G3 3000/5000/6000 Series Service Manual
Fig. 433
DSCN-0072