Park Brake Handle Assembly Replacement - Toro TITAN Service Manual

Park Brake Handle Assembly Replacement

Park Brake Handle Assembly Removal
Park Brake Handle Assembly Installation
Chassis: Service and Repairs
g321540
1. Cotter Pin
2. Intermediate Brake Rod
3. Torx Screw
4. Flange Bushing
1. Park the machine on a level surface and disengage the PTO. Stop the
engine, wait for all moving parts to stop, and remove key.
2. Disconnect the battery by removing the negative cable first, then the positive
cable from the battery.
3. Remove the left side console.
4. Re-install the fuel cap.
5. Remove the locking cotter pin securing the intermediate brake rod to the
park brake lever.
6. Remove the bolt and flange nut from the park brake lever assembly. Retain
the bushing and wave spring.
1. Assemble the bushings and wave spring over the bolt and through the park
brake.
Note: Assemble the bushings and wave spring over the bolt and through
the park brake
Figure 49
5. Wave Spring
6. Brake Flanged Bushing
7. Flange Nut
Page 5–24 Titan Service Manual
3438-774 Rev A