Suzuki SY413 Service Manual page 2075

7B1-22 AUTOMATIC TRANSMISSION
AUTOMATIC TRANSMISSION DIAGNOSTIC FLOW TABLE
Refer to the following pages for the details of each step.
STEP
1 Customer Complaint Analysis
1) Perform customer complaint analysis referring to the
next page.
Was customer complaint analysis performed according
to instruction on the next page?
2 Diagnostic Trouble Code (DTC) and Freeze Frame
Data Check, Record and Clearance
1) Check for DTC (including pending DTC) referring to
the next page.
Is there any DTC(s)?
3 Visual Inspection
1) Perform visual inspection referring to the next page.
Is there any faulty condition?
4 Visual Inspection
1) Perform visual inspection referring to the next page.
Is there any faulty condition?
5 Trouble Symptom Confirmation
1) Confirm trouble symptom referring to the next page.
Is trouble symptom identified?
6 Rechecking and Record of DTC / Freeze Frame Data
1) Recheck for DTC and freeze frame data referring to
"DTC CHECK" in this section.
Is there any DTC(s)?
7 Rechecking and Record of DTC / Freeze Frame Data
1) Recheck for DTC and freeze frame data referring to
"DTC CHECK" in this section.
Is there any DTC(s)?
8 Automatic Transmission Basic Inspection and
Symptom-To-Diagnosis Table
1) Check and repair according to "A / T BASIC CHECK"
and "TROUBLE DIAGNOSIS TABLE" in this section.
Are check and repair complete?
9 Troubleshooting for DTC
1) Check and repair according to applicable DTC flow
Table.
Are check and repair complete?
10 Check for Intermittent Problems
1) Check for intermittent problems referring to the next
page.
Is there any faulty condition?
11 Final Confirmation Test
1) Clear DTC if any.
2) Perform final confirmation test referring to the next
page.
Is there any problem symptom, DTC or abnormal
condition?
ACTION YES
Go to Step 2.
1) Print DTC and freeze
frame data or write
them down and clear
them by referring to
"DTC CLEARANCE"
in this section.
2) Go to Step 3.
1) Repair or replace
malfunction part.
2) Go to Step 11.
Go to Step 6.
Go to Step 9.
Go to Step 9.
Go to Step 11.
1) Repair or replace
malfunction part(s).
2) Go to Step 11.
Go to Step 6.
NO
Perform customer
complaint analysis.
Go to Step 4.
Go to Step 5.
Go to Step 8.
Go to Step 7.
Go to Step 8.
Go to Step 10.
1) Check and repair
malfunction
part(s).
2) Go to Step 11.
Go to Step 11.
End.