Suzuki SY413 Service Manual page 2567

9J-98 AIR BAG SYSTEM
1. Short deployment harness leads.
[A]
[B]
[A]: Driver side for left hand steering vehicle
[B]: Driver side for right hand steering vehicle
1. Stretch deployment harness to its full length 10 m (33 ft).
2. Drop clutch blanket or similar item.
5) Check that there is no open/short or damage in special tool
(deployment harness). If any faulty condition is found, do not
use it and be sure to use new deployment harness.
Special Tool
(A): 09932-75030
6) Short the two deployment harness leads together by fully seat-
ing one banana plug into the other.
WARNING:
Deployment wires shall remain shorted and not be
connected to a power source until the pretensioner
is to be activated.
Special Tool
1. Shorted (A): 09932-75030
7) Connect the deployment harness connector to the seat belt
pretensioner and lock the connector with lock lever.
Special Tool
(A): 09932-75030
8) Route deployment harness out the vehicle.
9) Verify that the inside of the vehicle and the area surrounding the
vehicle are clear of all people and loose or flammable objects.
10) Stretch the deployment harness to its full length 10 m (33 ft).
11) Place a power source near the shorted end of the deployment
harness. Recommended application: 12 Volts minimum, 2
amps minimum. A vehicle battery is suggested.
12) Completely cover windshield area and front door window
openings with a drop cloth, blanket to similar item. This re-
duces the possibility of injury due to possible fragmentation of
the vehicle's glass or interior.
13) Notify all people in the immediate area that you intend to acti-
vate the seat belt pretensioner.
NOTE:
When the pretensioner activates, the rapid gas expansion
will create a substantial report. Wear suitable ear protec-
tion. Notify all people in the immediate area that you in-
tend to activate the seat belt pretensioner and suitable ear
protection should be worn.