Suzuki SY413 Service Manual page 2492

DIAGNOSTIC TROUBLE CODE TABLE (Page 2 of 2)
DIAGNOSTIC TROUBLE CODE
NO. MODE
41
42
43
44
45
46
47
48
51
71
61
NOTE:
D When 2 or more codes are indicated, the lowest numbered code will appear first.
D If a code not listed on the table is displayed, then the SDM is faulty.
D Current DTC and history DTC can be identified by lighting and flashing of "AIR BAG" warning lamp as
follows.
"AIR BAG" warning lamp after
ignition switch ON
"AIR BAG" warning lamp when
grounding diagnosis switch
However, if a multiple number of DTC are set an even one of them is a current DTC, "AIR BAG" warning
lamp remains on after ignition switch is turned ON. Therefore, it is not possible to identify any of them
as to whether it is a current one or a history one. (But use of SUZUKI scan tool will make identification
possible.)
Resistance high
Resistance low
Driver pretensioner
circuit
Short to ground
Short to power circuit
Resistance high
Resistance low
Passenger preten- g
sioner circuit
Short to ground
Short to power circuit
Frontal crash detected
Internal fault
SDM
"AIR BAG" warning lamp
circuit failure
Current DTC Is set. (Ab-
normality exists at present.)
Remains ON.
Current DTC is displayed.
AIR BAG SYSTEM 9J-23
DIAGNOSIS DIAGNOSIS
Diagnose trouble accord-
ing to "DIAGNOSTIC i t "DIAGNOSTIC
FLOW TABLE" corre-
s onding to each code sponding to each code
No.
History DTC is set only. (Faulty condi-
tion occurred once in the past but nor-
mal conditIon is restored at present.)
Light up for 6 seconds and turns off.
History DTC is displayed.