Suzuki SY413 Service Manual page 1846

1. Gear shift shaft
2. Boot
3. Differential side R oil seal
A: Breather (Bring it downward)
1. Gear shift arm
2. Gear shift shaft
1. Differential side L oil seal
MANUAL TRANSMISSION (G13 AND G16 ENGINE MODELS) 7A-21
5) Install gear shift shaft, boot, steel ball, spring and tighten bolt
with washer applied with sealant.
"C": SUZUKI BOND NO.1215, 99000-31110
Tightening Torque
(b): 13 N·m (1.3 kg-m, 9.5 lb-ft)
NOTE:
Bring breather of gear shift shaft boot downward.
6) Install differential side R oil seal until it becomes flush with case
surface by using special tool with hammer, and then apply
grease to its lip.
NOTE:
Face diff. side oil seal spring side inward.
"B": SUZUKI SUPER GREASE A, 99000-25010
Special Tool
(E): 09913-75810
7) Insert gear shift arm in gear shift shaft, then fasten them with
bolt applied with thread lock cement.
Tightening Torque
(c): 34 N·m (3.4 kg-m, 24.5 lb-ft)
LEFT CASE
1) If input oil gutter has been removed, install it with bolt applied
with thread lock cement
"A": Thread lock 1322, 99000-32110
Tightening Torque
(a): 10 N·m (1.0 kg-m, 7.5 lb-ft)
2) Install differential side L oil seal until it becomes flush with case
surface by using special tool with hammer, and then apply
grease to its lip.
NOTE:
Face oil seal spring side inward.
"B": SUZUKI SUPER GREASE A, 99000-25010
Special Tool
(A): 09913-75520