Suzuki SY413 Service Manual page 2028

1. Final gear bolt
2. Final gear
3. Torque wrench
4. Soft jawed vise
A: Deeper flange side from gear edge
1. Side bearing shim
1. Transmission case housing
2. Straightedge
4) Install speedometer drive gear.
5) Install diff. side bearing (R). Face its seal side inward and press-
fit it by using special tool with copper hammer. While press-fit-
ting, support differential assembly as illustrated so that left hand
1 Differential side
bearing is floating.
bearing (R)
2. Speedometer
Special Tool
drive gear
3. Differential gear
(A): 09951-76010
4. Differential case
(B): 09951-16060
5. Differential side
bearing (L)
6) Hold differential assembly with soft jawed vise, install final gear
and then tighten it with 8 bolts to specified torque.
NOTE:
Place offset side of final gear flange toward differential
case.
CAUTION:
Use of any other bolts than specified ones is prohib-
ited.
Tightening Torque
(a): 85 N·m (8.5 kg-m, 61.5 lb-ft)
Shim Adjustment For Differential Side Bearing
Before installing differential assembly to transmission case, select
a differential side bearing shim as follows.
1) With gasket removed, measure dimension "a" of transmission
case housing (from mating surface to bearing bore bottom) by
using straightedge and vernier caliper.
The dimension "a" can be obtained by subtracting straightedge
width "d" from measured value.
Dimension "a" = measured value – straightedge width "e"
AUTOMATIC TRANSMISSION (3 A/T) 7B-89