Suzuki SY413 Service Manual page 2579

1. No.1 cylinder 3. No.3 cylinder
2. No.2 cylinder 4. No.4 cylinder
GENERAL INFORMATION
STATEMENT ON CLEANLINESS AND CARE
(FOR G13/G16 ENGINE MODELS)
An automobile engine is a combination of many machined, honed,
polished and lapped surfaces with tolerances that are measured
in the thousands of an millimeter (ten thousands of an inch).
Accordingly, when any internal engine parts are serviced, care and
cleanliness are important.
Throughout this section, it should be understood that proper clean-
ing and protection of machined surfaces and friction areas is part
of the repair procedure. This is considered standard shop practice
even if not specifically stated.
D A liberal coating of engine oil should be applied to friction areas
during assembly to protect and lubricate the surfaces on initial
operation.
D Whenever valve train components, pistons, piston rings, con-
necting rods, rod bearings, and crankshaft journal bearings are
removed for service, they should be retained in order.
At the time of installation, they should be installed in the same
locations and with the same mating surfaces as when removed.
D Battery cables should be disconnected before any major work
is performed on the engine.
Failure to disconnect cables may result in damage to wire har-
ness or other electrical parts.
D Throughout this manual, the four cylinders of the engine are
identified by numbers; No.1, No.2, No.3 and No.4 counted front
crankshaft pulley side to flywheel side.
ENGINE (ENGINE WITHOUT WU TWC) 6-3