Suzuki SY413 Service Manual page 2401

9-32 BODY SERVICE
[A]
[B]
[A]: Hatch-back model
[B]: Wagon model
3) Using new brush, apply sufficient amount of primer for body
along body surface where window is to be adhered.
NOTE:
Be sure to refer to maker's instruction for proper handling
and drying time.
1. New brush
2. Primer for body
4) Clean glass surface to be adhered to window with clean cloth.
If cleaning solvent is used, let it dry for more than 10 minutes.
5) Install moldings to glass (Don't peel off paper of molding at this
stage). Warming moldings for over half an hour at 35 C (95 F)
temperature will facilitate work.(For hatch-back model)
6) Clean molding surface A with clean cloth. (Refer to left figure.)
(For hatch-back model)
1. Molding
2. Glass
7) Using new brush, apply sufficient amount of primer for glass
along glass surface to be adhered to window.
NOTE:
Be sure to refer to maker's instruction for proper han-
dling and drying time.
Do not touch primer coated surface.
Width "a": Approximately 13 mm (0.51 in.)
1. New brush
2. Primer for glass
3. Molding
4. Clip
5. Dam
6. Glass
7. Adhesive tape
"b": Approximately 16 mm (0.63 in.)
"c": Approximately 14 mm (0.55 in.)