Suzuki SY413 Service Manual page 2389

9-20 BODY SERVICE
12) Peel remaining paper from molding and dam.
13) Holding rubber sucker grips, place glass onto body by aligning
mating marks marked in step 5) and press it.
14) Attach roof molding.
1. Rubber sucker grip
15) Check for water leakage by running water from hose over win-
dow. If leakage is found, dry window and fill leaky point with
adhesive. If water still leaks even after that, remove glass and
start installation procedure all over again.
NOTE:
16) Install rear view mirror, roof molding, front pillar trims, sunvisor,
air ventilator garnish and wipers.
Do not use high pressure water.
Do not blow compressed air directly at adhesive ap-
plied part when drying.
Do not use infrared lamp or the like for drying.
CAUTION:
Upon completion of installation, note the following.
Sudden closing of door before adhesive is com-
pletely set may cause glass to become loose or to
come off. Therefore, if door is opened or closed
before adhesive is completely set, make sure to
open all door glasses and use proper care.
If molding is not securely in place, hold it down
with a tape until adhesive is completely set.
Each adhesive has its own setting time. Be sure to
refer to maker's instruction, check setting time of
adhesive to be used and observe precautions to
be taken before adhesive is set.
Refrain from driving till adhesive is completely set
so as to ensure proper and sufficient adhesion.