Suzuki SY413 Service Manual page 2562

1. Seat belt pretensioner (retractor assembly)
2. Webbing
3. 185 cm (6 feet) of clearance
4. Warning label attached side face up
1. Stretch deployment harness to full length 10 m (33 ft).
2. Connect connectors.
3. Power source (12V vehicle battery)
4. Short the two deployment harness leads.
6) Pull out the webbing fully as shown and cut it at the root of the
pretensioner (retractor assembly) as shown in the figure.
WARNING:
As the drum of the retractor assembly turns very
quickly as soon as the webbing is cut, fix the retrac-
tor assembly with a vise on the workbench and keep
your hands and fingers away from it when cutting the
webbing.
7) Clear a space on the ground about 185 cm (6 feet) in diameter
where the seat belt pretensioner is to be activated. A paved,
outdoor location where there is no activity is preferred. If an
outdoor location is not available, a space on the shop floor
where there is no activity and sufficient ventilation is recom-
mended.
Ensure no loose or flammable objects are within the activation
area.
8) Place the seat belt pretensioner with its warning label attached
side facing up as shown in the figure on the ground in the
space just cleared.
9) Stretch the deployment harness from the seat belt pretension-
er to its full length 10 m (33 ft).
10) Place a power source near the shorted end of the deployment
harness. Recommended application: 12 Volts minimum, 2
amps minimum. A vehicle battery is suggested.
11) Verify that the area around the seat belt pretensioner is clear
of all people and loose or flammable objects.
12) Verify that the seat belt pretensioner, with its warning label at-
tached side facing up as shown on the ground in the space just
cleared.
13) Connect the seat belt pretensioner to the deployment harness
connector and lock the connector with lock lever.
AIR BAG SYSTEM 9J-93