Suzuki SY413 Service Manual page 2124

1. Manual shift lever
2. Transmission range sensor
3. Transmission range sensor coupler
1. Output shaft speed sensor
1. Output shaft speed sensor
1. Output shaft speed sensor
INSPECTION
1) Disconnect transmission range sensor coupler.
2) Check that continuity exists as shown in below by moving selec-
tor lever.
Terminal No.
1 2
Switch
position
P
R
N
D
2
L
OUTPUT SHAFT SPEED SENSOR (A/T VSS)
INSPECTION
1) Disconnect negative cable at battery.
2) Disconnect output shaft speed sensor coupler.
3) Check resistance between output shaft speed sensor termi-
nals.
Output shaft speed sensor standard resistance:
648 – 792 W at 20 C (68 F)
REMOVAL
1) Disconnect negative cable at battery.
2) Disconnect output shaft speed sensor coupler.
3) Remove output shaft speed sensor by removing its bolt.
INSTALLATION
1) Apply A/T fluid to output shaft speed sensor O-ring.
2) Install output shaft speed sensor to A/T case and tighten bolt to
specified torque.
Tightening Torque
(a): 5.5 N·m (0.55 kg-m, 4.0 lb-ft)
3) Connect output shaft speed sensor coupler to output shaft
speed sensor.
4) Connect negative cable to battery.
AUTOMATIC TRANSMISSION 7B1-71
3 4 5 6 7 8 9