Suzuki SY413 Service Manual page 2565

9J-96 AIR BAG SYSTEM
ALWAYS PLACE SEAT BELT PRETENSIONER
ON WORKBENCH WITH ITS WARNING LABEL
ATTACHED SIDE FACING UP, AWAY FROM
LOOSE OBJECTS.
NOTE:
The remaining steps are to be followed in the unlikely
event that the seat belt pretensioner did not activate after
the following these procedures.
23) Ensure that the deployment harness has been disconnected
from the power source and that its two banana plugs have
been shorted together by fully seating one banana plug into
the other.
24) Disconnect the deployment harness from the seat belt preten-
sioner.
WARNING:
D For handling and storage of a live seat belt preten-
D Never carry the seat belt pretensioner by the wires
D When placing a live seat belt pretensioner on
Otherwise, personal injury may result.
25) Temporarily store the seat belt pretensioner with its warning la-
bel attached side facing up, away from the surface upon which
it rests. Refer to "PRECAUTIONS" in this section for details.
26) Contact your local distributor for further assistance.
1. Warning label
sioner, select a place where the ambient tempera-
ture below 655C (1505F), without high humidity
and away from electric noise.
or connector on the underside of the pretensioner.
bench or other surface, always face its warning la-
bel attached side up, away from the surface. As the
live seat belt pretensioner module must be placed
with its warning label attached side facing up,
place it on the workbench. It is also prohibited to
place anything on the warning label attached side
and stack seat belt pretensioners.