Suzuki SY413 Service Manual page 2549

Table of Contents

Advertisement

9J-80 AIR BAG SYSTEM
DRIVER/PASSENGER AIR BAG (INFLATOR) MODULES DISPOSAL
WARNING:
Failure to follow proper air bag (inflator) module disposal procedures can result in air bag deploy-
ment which may cause personal injury. Undeployed air bag (inflator) modules must not be disposed
of through normal refuse channels.
The undeployed air bag (inflator) module contains substances that can cause severe illness or per-
sonal injury if the sealed container is damaged during disposal.
Do not dispose of the live (undeployed) air bag (inflator) modules (driver/passenger). When disposal of the air bag
(inflator) module(s) or entire vehicle including the air bag (inflator) module(s) is necessary, deploy the air bag ac-
cording to the procedure described under "DEPLOYMENT OUTSIDE VEHICLE" or "DEPLOYMENT INSIDE VE-
HICLE" in this section.
The method employed depends upon the final disposition of the particular vehicle, as noted in "DEPLOYMENT
OUTSIDE VEHICLE" and "DEPLOYMENT INSIDE VEHICLE" in this section.
Deployment Outside Vehicle
Deployment Inside Vehicle
DEPLOYMENT OUTSIDE VEHICLE
Use this procedure when the vehicle itself is used again (only the air bag (inflator) module(s) are disposed of).
WARNING:
D The following precautions must be observed for this work. Failure to observe any of them may re-
sult in personal injury.
D To avoid an accidental deployment, this work should be performed by no more than one person.
D The procedure should be followed strictly as described here.
D Be sure to read "HANDLING PRECAUTIONS" for the air bag (inflator) module beforehand.
D Never connect deployment harness to any power source before connecting deployment harness
to the air bag (inflator) module. Deployment harness shall remain shorted and not be connected
to a power source until the air bag is to be deployed.
D Since a large amount of smoke is produced when air bag is deployed, select a well-ventilated area.
D The air bag (inflator) module will immediately deploy the air bag when a power source is connected
to it. Wear safety glasses throughout this entire deployment and disposal procedure.
D Wear suitable ear protection when deploying air bag. Also, advise those who are in the area close
to deployment site to wear suitable ear protection.
D Do not deploy driver and passenger air bag (inflator) modules at the same time.
The following procedure requires use of special tool(s) (deployment harness and/or passenger air bag (inflator)
module deployment fixture). Do not attempt procedure without it (them).
. . . . . . . . . . . .
Disposing of the air bag (inflator) module(s) only
(i.e., the vehicle itself will be used again).
. . . . . . . . . . . . . .
Scrapping the entire vehicle including the air bag (inflator) module(s).

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sy416Sy418

Table of Contents