8-26 BODY ELECTRICAL SYSTEM
HAZARD SWITCH
Removal
1) Remove heater control lever knobs.
2) Remove center console garnish.
3) Detach hazard switch.
4) Disconnect hazard switch coupler.
1. Center console garnish mounting screw
Inspection
Use a circuit tester to check the continuity of each switch position.
If any continuity is not obtained, replace switch.
6
8
7
3
2
1
4
5
OFF
ON
Installation
Reverse removal procedure for installation.
HAZARD RELAY
The turn signal/hazard relay is located in the junction/fuse box.
Inspection
Connect battery and tester as shown.
Unless a continued click sound is heard, replace relay.
1. Hazard relay