Suzuki SY413 Service Manual page 2387

9-18 BODY SERVICE
Mark mating marks
Upper side
INSTALLATION
1) Using cleaning solvent, clean window frame (body) where glass
is to be adhered. (Let it dry for more than 10 minutes.)
2) Install spacers (2 pcs) to lower side of window frame (body).
3) Peel paper from one side of new glass spacer and attach that
lower side to windshield glass.
1. Glass spacer
4) To determine installing position of glass to body, position glass
against body so that clearance between upper end of glass and
body is about 6.5 mm (0.256 in.) and clearances between each
side end (right & left) of glass and body are even. Then mark
mating marks on glass and body as shown in figure. Upper
clearance can be adjusted by moving stoppers position.
Clearance "a": 6.5 mm (0.256 in.)
1. Glass stopper
5) Using new brush, apply sufficient amount of primer for body
along body surface where windshield glass is to be adhered.
NOTE:
Be sure to refer to maker's instruction for proper handling
and drying time.
1. New brush
2. Primer for body
6) Install upper molding to glass. Warming molding for over half an
hour at 35 C (95 F) temperature will facilitate work.
7) Clean glass surface to be adhered to body with clean cloth.
If cleaning solvent is used, let it dry for more than 10 minutes.
8) Clean molding surface (A) with clean cloth as shown.
1. Molding
2. Blank
3. Glass
4. Glass spacer