Suzuki SY413 Service Manual page 2391

9-22 BODY SERVICE
[A] [B]
[A]: Hatch-back model
[B]: Wagon model
[A] [B]
1. Knife
2. Adhesive
Adhesive materials and tools required for removal and installation.
One component urethane adhesive and primers used in com-
bination (For one sheet of window glass).
Adhesive (120 g (4.3 oz.) for hatch-back model)
Primer for glass (20 g (0.7 oz.))
Primer for body (20 g (0.7 oz.))
Primer for urethane (molding) (20 g (0.7 oz.) for hatch-back
model)
Eyeleteer
Piano string
Brush for primer application (3 pcs)
Knife
Rubber sucker grip
Sealant gun (for filling adhesive)
Putty spatula (for correcting adhered parts)
REMOVAL
1) Cut molding all around quarter glass with knife.
2) Using a tape, cover body surface around quarter window glass
to prevent any damage.
3) Remove quarter window trim.
4) Drill a hole with an eyeleteer through adhesive and let a piano
string through it.
1. Eyeleteer
5) Cut adhesive all around quarter glass with piano string.
NOTE:
Use piano string as close to glass as possible so as to pre-
vent damage to body.
1. Piano string
2. Glass
3. Tape
4. Adhesive
6) Using a knife, smooth adhesive remaining on body side so that
it is 2 – 3 mm thick all around.
7) Where adhesive dam will be attached, remove adhesive until
painted surface is exposed and clean.
[A]: Hatch-back model
[B]: Wagon model
(220g (7.8 oz.) for Wagon model)