Suzuki SY413 Service Manual page 1657

3G-20 SUSPENSION CONTROL SYSTEM
TERMINAL
A1 A1 – B6 B6 Brake light switch Brake light switch
A2 – A4 Front actuator 1 and 2
A2 – A12 Front actuator 1 and 3
A4 – A12 Front actuator 2 and 3
A3 – A5 Rear actuator 2 and 3
A3 – A6 Rear actuator 2 and 1
A5 – A6 Rear actuator 3 and 1
B4 B4 – Body ground Body ground Diagnosis switch terminal Diagnosis switch terminal
B15 – Body ground Ground
RESISTANCE CHECK
1) Disconnect suspension control module couplers from suspen-
sion control module with ignition switch OFF.
CAUTION:
Never touch terminals of suspension control module
itself or connect voltmeter of ohmmeter.
2) Check resistance of each two terminals of disconnected cou-
plers.
CAUTION:
D Be sure to connect ohmmeter probe from wire har-
ness side of coupler.
D Be sure to turn OFF ignition switch for this check.
D Resistance in table below represents that when
parts temperature is 205C (685F).
CIRCUIT
RESISTANCE
NORMAL
continuity Brake pedal depressed
infinity Brake pedal not depressed
2.3 – 7.0W 2 3 7 0W
continuity Diagnosis switch terminal grounded
infinity Diagnosis switch terminal not grounded
continuity
CONDITION
–––––