Suzuki SY413 Service Manual page 2335

Table of Contents

Advertisement

IMMOBILIZER CONTROL SYSTEM
WARNING:
For vehicles equipped with Supplemental Restraint (Air Bag) System
D Service on and around the air bag system components or wiring must be performed only by an
authorized SUZUKI dealer. Refer to "Air Bag System Components and Wiring Location View" un-
der "General Description" in air bag system section in order to confirm whether you are perform-
ing service on or near the air bag system components or wiring. Please observe all WARNINGS
and "Service Precautions" under "On-Vehicle Service" in air bag system section before perform-
ing service on or around the air bag system components or wiring. Failure to follow WARNINGS
could result in unintentional activation of the system or could render the system inoperative. Ei-
ther of these two conditions may result in severe injury.
D Technical service work must be started at least 90 seconds after the ignition switch is turned to
the "LOCK" position and the negative cable is disconnected from the battery. Otherwise, the sys-
tem may be activated by reserve energy in the Sensing and Diagnostic Module (SDM).
NOTE:
Whether the immobilizer indicator lamp is used in the particular vehicle or not depends on vehicle specifi-
cations. If there is a exhaust No.1 pipe with manifold catalytic converter, the vehicle is equipped with immo-
bilizer indicator lamp and if there isn't , it is not equipped with immobilizer indicator lamp. For details of
exhaust No.1 pipe, refer to Section 6K in this manual.
GENERAL DESCRIPTION
Ignition Key
. . . . . . . . . . . . . . . . . . . . . . . . . . .
Coil Antenna
. . . . . . . . . . . . . . . . . . . . . . . . . .
Immobilizer Control Module & Engine
Control Module/Powertrain Control Module
(ECM/PCM)
. . . . . . . . . . . . . . . . . . . . . . . . . .
On-board Diagnostic System
(Self-diagnosis function)
DIAGNOSIS
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Precautions in Diagnosing Troubles
Diagnostic Flow Table
<Vehicle not equipped with immobilizer
indicator lamp>
. . . . . . . . . . . . . . . . . . . . . . .
Diagnostic Flow Table
<Vehicle equipped with immobilizer
indicator lamp>
. . . . . . . . . . . . . . . . . . . . . . .
Diagnostic Trouble Code (DTC) Check
(Immobilizer Control Module)
SECTION 8G
(IF EQUIPPED)
CONTENTS
. . . . . . . . . . . . . . . .
8G- 3
8G- 5
8G- 5
8G- 5
. . . . . . . . . . . . . . .
8G- 6
8G- 8
. . . . . .
8G- 8
8G-11
8G-12
. . . . . . . . . . .
8G-13
IMMOBILIZER CONTROL SYSTEM (IF EQUIPPED) 8G-1
Diagnostic Trouble Code (DTC) Check
(ECM/PCM)
. . . . . . . . . . . . . . . . . . . . . . . . . .
Diagnostic Trouble Code Table
TABLE A Code (DTC) is not Outputted from
Diagnostic Output Terminal of Immobilizer
Diagnostic Coupler
. . . . . . . . . . . . . . . . . . . .
TABLE B Immobilizer Indicator Lamp Check
(Immobilizer Indicator Lamp does not Light
at Ignition Switch ON)
. . . . . . . . . . . . . . . . .
TABLE C Immobilizer Indicator Lamp Check
(Immobilizer Indicator Lamp Remains on
after Engine Starts)
. . . . . . . . . . . . . . . . . . .
DTC11 Transponder Code Not Matched
DTC31 Transponder Code Not Registered 8G-20
DTC12 Fault in Immobilizer Control
Module
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
DTC13 No Transponder Code Transmitted
or Coil Antenna Opened/Shorted
8G-13
. . . . . . . . . .
8G-15
8G-16
8G-17
8G
8G-18
. .
8G-19
8G-21
. . . . . . . .
8G-22

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sy416Sy418

Table of Contents