Suzuki SY413 Service Manual page 1863

7A-38 MANUAL TRANSMISSION (G13 AND G16 ENGINE MODELS)
1. Gear shift & select shaft assembly
2. Gear shift interlock plate
3. Gear shift yoke
4. Bolt
5. Gear shift interlock bolt
1. Backup lamp switch
2. Gear shift guide case bolt
3. Left case cap bolt
3) Install gear shift yoke and joint it with gear shift arm.
4) Install gear shift & select shaft assembly into transmission and
joint its bottom end with gear shift yoke.
NOTE:
When installing gear shift & select shaft assembly, posi-
tion gear in neutral so that gear shift interlock plate will go
in smoothly.
5) Tighten yoke and shaft with bolt applied with thread lock ce-
ment.
"B": Thread lock 1322, 99000-32110
Tightening Torque
(c): 34 N·m (3.4 kg-m, 24.5 lb-ft)
6) Install gear shift interlock bolt with washer and tighten it to
specification.
Tightening Torque
(c): 23 N·m (2.3 kg-m, 17.0 lb-ft)
7) Clean mating surface of left case and put gear shift guide case
applied with sealant on it.
Sealant: SUZUKI BOND No.1215, 99000-31110
8) Place wiring harness clamp bracket and fasten it together with
gear shift guide case.
Tightening Torque
(d): 10 N·m (1.0 kg-m, 7.5 lb-ft)
9) Install backup lamp switch and clamp its lead.
Tightening Torque
(e): 20 N·m (2.0 kg-m, 14.5 lb-ft)
10) Clean left case cap and mating surface of left case, check
condition of O-ring and then fasten cap with 3 bolts.
Tightening Torque
(d): 10 N·m (1.0 kg-m, 7.5 lb-ft)
11) Check input shaft for rotation in each gear position.
12) Also confirm function of backup lamp switch in reverse posi-
tion by using ohmmeter.