Suzuki SY413 Service Manual page 1680

1. Screwdriver
2. Pliers
3. Boot band
4. Boot
5. Measure
6. Forward rotation
1. Hammer
2. Punch
REASSEMBLY
Judging from abnormality noted before disassembly and what is
found through visual check of component parts after disassembly,
prepare replacing parts and proceed to reassembly. Make sure
that wheel side joint assembly and tripod joint housing are washed
thoroughly and air dried, and boots are cleaned with cloth if they
are to be reused.
DRIVE SHAFT (4 AlT MODEL)
1) Apply grease to wheel side joint. Use black grease in tube in-
cluded in wheel side boot set.
2) Install wheel side boot on shaft.
3) Fill up boot inside with grease.
4) Fix boot with boot band.
i) Fit boot band into groove in boot.
ii) Tighten boot band till its outer diameter value becomes as
specified below.
Diameter: Approx. 79 mm (3.11 in.)
iii) Fold boot band over metal fixture.
iv) Using a punch, caulk the center of boot band folded over
metal fixture.
NOTE:
Be careful not to damage boot.
FRONT DRIVE SHAFT 4A-5