Suzuki SY413 Service Manual page 1902

1. Drive shaft
2. Center bearing support
1. Steering knuckle
2. Ball stud bolt
3. Link nut
4. Lower arm
6) Insert drive shaft joint or center drive shaft to differential gear.
With right side drive shaft, install center bearing support.
CAUTION:
D Be careful not to scratch oil seal lip with drive shaft
joint while inserting.
D Make sure to insert drive shaft joint fully and seat
its snap ring as it was.
D Do not hit joint boot with hammer or the like. Noth-
ing but hands is allowed to use when inserting
joint.
Tightening Torque
(a): 50 N·m (5.0 kg-m, 36.5 lb-ft)
7) Install exhaust No.1 pipe.
8) Connect ball stud with knuckle and fasten with bolt to specifi-
cation.
Tightening Torque
(b): 60 N·m (6.0 kg-m, 43.5 lb-ft)
9) Install stabilizer bar to suspension arm and fasten link nut to
specification.
Tightening Torque
(c): 28 N·m (2.8 kg-m, 20.5 lb-ft)
10) Fill transmission oil as specified and make sure that oil has
been sealed with oil seal.
MANUAL TRANSMISSION 7A2-11