Suzuki SY413 Service Manual page 2544

1. SDM
2. SDM bolt
3. SDM connector
4. Arrow
[A]
[B]
[A]: Driver side
[B]: Passenger side
1. Steering support member lower brace
2. Console box extension
INSTALLATION
1) Check that none of the following faulty conditions exists.
D Bend, scratch, deformity in vehicle body mounted on SDM
D Foreign matter or rust on mating surface of vehicle body
mounted on SDM
2) Install SDM (with SDM plate) to vehicle.
CAUTION:
Ensure that arrow on the SDM is pointing toward the
front of the vehicle.
3) Tighten SDM bolts to specified torque.
Tightening Torque
(a): 5.5 N·m (0.55 kg-m, 4.0 lb-ft)
4) Connect SDM connector to SDM securely.
5) Install steering support member lower brace.
6) Install console box extension.
7) Connect negative cable to battery.
8) Enable air bag system. Refer to "ENABLING AIR BAG SYS-
TEM" in this section.
AIR BAG SYSTEM 9J-75