Suzuki SY413 Service Manual page 2560

SEAT BELT PRETENSIONERS DISPOSAL
WARNING:
Failure to follow proper seat belt pretensioner (retractor assembly) disposal procedures can result
in pretensioner activation which may cause personal injury. Inactivated seat belt pretensioner must
not be disposed of through normal refuse channels.
The inactivated seat belt pretensioner contain substances that can cause severe illness or personal
injury if the sealed container is damaged during disposal.
Do not dispose of the live (inactivated) seat belt pretensioners.
The method employed depends upon the final disposition of the particular vehicle, as noted in "ACTIVATION OUT-
SIDE VEHICLE" and "ACTIVATION INSIDE VEHICLE" in this section.
Activation Outside Vehicle
Activation Inside Vehicle
ACTIVATION OUTSIDE VEHICLE
Use this procedure when the vehicle itself is used again (only the seat belt pretensioner(s) (retractor assembly)
are disposed of).
WARNING:
The following precautions must be observed for this work. Failure to observe any of them may result
in personal injury.
D To avoid an accidental activation, this work should be performed by no more than one person.
D The procedure should be followed strictly as described here.
D Be sure to read "PRECAUTIONS" in this section for the seat belt pretensioner beforehand.
D Never connect deployment harness to any power source before connecting deployment harness
to the seat belt pretensioner. Deployment harness shall remain shorted and not be connected to
a power source until the pretensioner is to be activated.
D Since a large amount of smoke is produced when pretensioner is activated, select a well-ventilated
area.
D The seat belt pretensioner will immediately activate the pretensioner when a power source is con-
nected to it. Wear safety glasses throughout this entire activation and disposal procedure.
D Wear suitable ear protection when activating pretensioner. Also, advise those who are in the area
close to activation site to wear suitable ear protection.
D Do not activate driver and passenger seat belt pretensioners at the same time.
The following procedure requires use of special tools (deployment harness and pretensioner service adapter kit).
Do not attempt procedure without them.
. . . . . . . disposing of the seat belt pretension(s) only (i.e.,the vehicle itself will be used
again).
. . . . . . . . . scrapping the entire vehicle including the seat belt pretensioner(s).
AIR BAG SYSTEM 9J-91