Suzuki SY413 Service Manual page 2097

7B1-44 AUTOMATIC TRANSMISSION
DTC P0705/DTC NO.34 TRANSMISSION RANGE SENSOR CIRCUIT MALFUNCTION
WIRING DIAGRAM
TROUBLESHOOTING
STEP
1 Was "A / T DIAGNOSTIC FLOW TABLE"
performed?
2 Check Transmission Rang Sensor Circuit for
Operation referring to "TRANSMISSION RANGE
SENSOR CIRCUIT CHECK" in this section.
Are check result satisfactory?
3 Check Select Cable for Adjustment referring to
"SELECT CABLE ADJUSTMENT" in this section.
Is it adjusted correctly?
4 Check Transmission Range Sensor for Installation
Position.
1) Shift select lever to "N" range.
2) Check that "N" reference line on switch and
center line on shaft are aligned.
Are they aligned?
5 Check Transmission Range Sensor referring to
"TRANSMISSION RANGE SENSOR INSPEC-
TION" in this section.
Are check results satisfactory?
ACTION
1. TCM
2. Transmission range sensor
3. From ignition switch
4. Shift indicator
5. Backup lamp
6. Terminal arrangement of TCM coupler
(Viewed from harness side)
YES
Go to Step 2.
If voltmeter is used in
Step 2, check TCM to
connector connection for
poor connection.
If OK, intermittent trouble.
Check for intermittent
referring to "INTERMIT-
TENT AND POOR CON-
NECTION" in Section 0A.
Go to Step 4.
Go to Step 5.
"Br/Y", "W/B", "R/W",
"W / R", "Y / R", "Y" or
"R / B" circuit open or
short.
If wires and connections
are OK, substitute a
known-good TCM and
recheck.
NO
Go to "A / T DIAG-
NOSTIC FLOW
TABLE".
Go to Step 3.
Adjust.
Adjust.
Replace TR sensor.