Suzuki SY413 Service Manual page 1782

5-88 BRAKES
As done above, apply 100 kg/cm
check that rear brake pressure then is within specification as given
below.
Front brake
10,000 kPa
100 kg / cm
1422 psi
4) If rear brake pressure is not within specification, adjust it by
changing bolt "A" tightening position as follows.
Tightening Torque
(a):23 N·m (2.3 kg-m, 17.0 lb-ft)
D If rear brake pressure is higher than specification, move bolt
"A" rearward and if it is lower, forward.
D Repeat steps 3) and 4) until rear brake pressure is within
1. LSPV lever
specification.
2. LSPV spring
3. LSPV stay D After adjustment, be sure to torque nut to specification.
5) Upon completion of fluid pressure test, bleed brake system and
perform brake test.
2
Rear brake
3 Door
1.3 , 1.6
4 Door 4 Door
2
1.6 4WD, 1.8
1.3 , 1.6
WAGON WAGON
1.8
pressure to front brake and
4,600 – 5,000 kPa
46 – 50 kg / cm
654 – 711 psi
5,000 – 5,400 kPa
2WD 50 – 54 kg / cm
711 – 768 psi
5,400 – 5,800 kPa
54 – 58 kg / cm
768 – 825 psi
5,800 – 6,200 kPa
58 – 62 kg / cm
825 – 882 psi
7,200 – 7,600 kPa
72 –76 kg / cm
1024 – 1081 psi
2
2
2
2
2