Suzuki SY413 Service Manual page 2490

1. Data link connector (DLC)
1. Diagnosis switch terminal
2. Service wire
DIAGNOSTIC TROUBLE CODE (DTC) CLEARANCE
[Using SUZUKI scan tool]
1) Turn ignition switch OFF.
2) Connect SUZUKI scan tool to data link connector (DLC) in the
same manner as when making this connection for DTC check.
Special Tool
(A): 09931-76011(SUZUKI scan tool)
(B): Mass storage cartridge
(C): 09931-76030 (16/14 pin DLC cable)
3) Turn ignition switch ON.
4) Erase DTC accord in to instructions displayed on SUZUKI scan
tool.
Refer to SUZUKI scan tool operator's manual for further details.
5) After completing the check, turn ignition switch OFF and discon-
nect SUZUKI scan tool from data link connector (DLC).
6) Perform "DIAGNOSIS TROUBLE CODE (DTC) CHECK" and
confirm that normal DTC (DTC 12) is displayed and not mal-
function DTC.
NOTE:
If DTC 51 or DTC 71 is stored in SDM, it is not possible to clear
DTC.
[Not using SUZUKI scan tool]
1) Turn ignition switch ON and wait about 6 seconds or more.
2) Using service wire, repeat shorting and opening between diag-
nosis switch terminal and ground terminal on "AIR BAG" moni-
tor coupler 5 times at about 1 second intervals.
3) Perform "DIAGNOSIS TROUBLE CODE (DTC) CHECK" and
confirm that normal DTC (DTC 12) is displayed and not mal-
function DTC.
NOTE:
If DTC 51 or DTC 71 is stored in SDM, it is not possible to
clear DTC.
AIR BAG SYSTEM 9J-21