Front Disc Brake - Suzuki SY413 Service Manual

1. Caliper
2. Caliper pin bolt
3. Disc
1. Caliper pin bolts

FRONT DISC BRAKE

REMOVE AND INSTALL PAD
(SHOE &LINING)
REMOVAL
1) Hoist vehicle and remove wheel.
2) Remove caliper pin bolts.
3) Remove caliper from caliper carrier.
1. Caliper
2. Wire hook
3. Pad NOTE:
Hang removed caliper with a wire hook or the like so as to
prevent brake hose from bending and twisting excessively
or being pulled.
Don't operate brake pedal with pads removed.
4) Remove pads.
INSTALLATION
NOTE:
See NOTE at the beginning of this section.
1) Install pad shims (plates) and pads.
1. Shims (plates)
2. Pads
3. Caliper carrier
2) Install caliper and torque caliper pin bolts to specification.
NOTE:
Make sure that boots are fit into groove securely.
Tightening Torque
(a): 22 N
3) Torque front wheel nuts to specification.
Tightening Torque
(b): 85 N
4) Upon completion of installation, perform brake test.
.
m (2.2 kg-m, 16.0 lb-ft)
.
m (8.5 kg-m, 61.5 lb-ft)
BRAKES 5-37