Suzuki SY413 Service Manual page 2402

[A]
[B]
[A]: Hatch-back model
[B]: Wagon model
8) Using new brush, apply sufficient amount of primer for molding
(Urethane) to surface A as shown in figure. (For hatch-back
model)
NOTE:
Be sure to refer to maker's instruction for proper han-
dling and drying time.
Do not touch primer coated surface.
1. Molding
2. Glass
9) Apply adhesive along upper and lower molding as shown.
NOTE:
Start from bottom side of glass.
Height of applied adhesive should exceed that of trim
and molding.
Adhesive should be applied evenly especially in height.
Height "a"
Width "b"
Dimension "c" : Approximately 5 mm (0.20 in.)
Be careful not to damage primer.
Press glass against body quickly after adhesive is ap-
plied.
Use of rubber sucker grips is helpful to hold and carry
glass after adhesive is applied.
10) Peel paper from moldings and window trim.
1. Adhesive
2. Glass
3. Molding
4. Spacer
5. Dam
6. Adhesive tape
: Approximately 14 mm (0.55 in.)
: Approximately 7 mm (0.28 in.)
: Approximately 3 mm (0.12 in.)
"d" : Approximately 1.5 mm (0.06 in.)
"e" : Approximately 22 mm (0.87 in.)
BODY SERVICE 9-33