Suzuki SY413 Service Manual page 1991

7B-52 AUTOMATIC TRANSMISSION (3 A/T)
1. Throttle valve cam
2. Oil pressure control cable end
1. Oil pressure control cable
(A): Adjusting nuts
2. cable cover
(B): Adjusting nuts
3. Accelerator cable
OIL PRESSURE CONTROL CABLE
REMOVAL
1) Disconnect oil pressure control cable from accelerator cable af-
ter removing cable cover.
2) Drain transmission fluid.
3) Remove oil pan.
4) Disconnect oil pressure control cable from throttle valve cam.
NOTE:
Oil pressure control cable can be disconnected from
throttle valve cam without removal of 2nd brake solenoid.
5) Disconnect oil pressure control cable from transmission case.
INSTALLATION
Reverse removal procedure for installation.
After connecting oil pressure control cable to accelerator cable,
check and adjust oil pressure control cable play. Adjusting proce-
dure is below.
Upon completion of installation, warm up transmission and check
for fluid level and leakage. (Refer to "FLUID LEVEL".)
ADJUSTMENT
1) With cable cover removed, adjust clearance "a" to specification
by turning nuts (B). Nuts (A) can be used for this adjustment if
necessary.
Clearance "a": 0 – 0.5 mm (0 – 0.02 in.)
2) Tighten nuts and install cable cover.
Tightening Torque
(A): 13 N·m (1.3 kg-m, 9.5 lb-ft)
(B): 13 N·m (1.3 kg-m, 9.5 lb-ft)