Suzuki SY413 Service Manual page 2552

[A]
[B]
[A]: Driver (inflator) module
[B]: Passenger (inflator) module
1. Stretch deployment harness to full length 10 m (33 ft).
2. Connect connectors.
3. Power source (12V vehicle battery)
4. Short the two deployment harness leads.
8) Stretch the deployment harness from the driver or passenger
air bag (inflator) module to its full length 10 m (33 ft).
9) Place a power source near the shorted end of the deployment
harness. Recommended application: 12 Volts minimum, 2
amps minimum. A vehicle battery is suggested.
10) Verify that the area around the driver or passenger air bag (infla-
tor) module is clear of all people and loose or flammable objects.
11) Verify that the driver air bag (inflator) module is resting with its
vinyl trim cover facing up.
Verify that the passenger air bag (inflator) module is firmly and
properly secured in passenger air bag (inflator) module de-
ployment fixture (special tool).
12) Connect the driver or passenger air bag (inflator) module to
the deployment harness connector and lock connector with
lock lever.
13) Notify all people in the immediate area that you intend to
deploy the air bag (inflator) module.
NOTE:
D When the air bag deploys, the rapid gas expansion will
create a substantial report. Wear suitable ear protec-
tion. Notify all people in the immediate area that you in-
tend to deploy the air bag (inflator) module and suitable
ear protection should be worn.
D When the air bag deploys, the driver air bag (inflator)
module may jump about 30 cm (one foot) vertically. This
is a normal reaction of the driver air bag (inflator) module
to the force of the rapid gas expansion inside the air bag.
D After the air bag (inflator) module has been deployed,
the surface of the air bag may contain a powdery resi-
due. This powder consists primarily of cornstarch
(used to lubricate the bag as it inflates) and byproducts
of the chemical reaction.
WARNING:
Safety precautions must be observed when handling
a deployed air bag (inflator) module.
D After deployment, the metal surfaces of the air bag
(inflator) module will be very hot. Do not touch the
metal areas of the driver or passenger air bag (infla-
tor) module for about 30 minutes after deployment.
D Do not place the deployed air bag (inflator) module
near any flammable objects.
D Do not apply water, oil, etc. to deployed air bag (in-
flator) module.
D If the deployed air bag (inflator) module must be
moved before it is cool, wear gloves and handle by
the air bag or vinyl trim.
Failure to follow procedures may result in fire or per-
sonal injury.
AIR BAG SYSTEM 9J-83