Suzuki SY413 Service Manual page 1990

1. Coupler
2. 2nd brake solenoid valve
3. Direct clutch solenoid valve
1. Coupler
2. Harness clamp
3. Output shaft speed sensor
INSTALLATION
1) Install solenoid valve wire harness to transmission case. If
grommet seal (O ring) is damaged, replace.
2) Install direct clutch and 2nd brake solenoid valves to lower valve
body. If solenoid seal (O ring) is damaged, replace.
Tightening Torque
(a): 8 N·m (0.8 kg-m, 6.0 lb-ft)
3) Connect solenoid valve wires to each solenoid valve.
4) Install oil pan to transmission and then refill transmission fluid.
5) Connect solenoid valve wire harness coupler.
6) Upon completion of installation, warm up transmission and
check for fluid level and leakage. (Refer to "FLUID LEVEL".)
OUTPUT SHAFT SPEED SENSOR (A/T VSS)
1) Undo wiring harness clamp.
2) Disconnect output shaft speed sensor coupler.
3) Remove output shaft speed sensor bolt.
4) Pull out output shaft speed sensor by gripping sensor body.
5) For installing, reverse removal procedure.
NOTE:
Check to be sure that O ring is in good condition.
Tightening Torque
(a): 8 N·m (0.8 kg-m, 6.0 lb-ft)
VEHICLE SPEED SENSOR (VSS, SPEEDOM-
ETER DRIVEN GEAR)
Refer to SECTION 7A.
AUTOMATIC TRANSMISSION (3 A/T) 7B-51