Suzuki SY413 Service Manual page 1871

7A1-4 MANUAL TRANSMISSION (J18 ENGINE MODEL)
1. Oil drain plug
2. Oil level/filler plug
Viscosity chart
SAE
ON-VEHICLE SERVICE
OIL CHANGE
1) Before changing or inspecting oil, be sure to stop engine and lift
vehicle horizontally.
2) With vehicle lifted up, check oil level and leakage.
If leakage exists, correct it.
3) Drain old oil and fill new specified oil by specified amount (up to
level hole).
4) Torque drain and level/filler plugs as specified below. Apply
sealant to thread of drain plug before installation.
"A": Sealant 99000-31110
Tightening Torque
(a): 21 N·m (2.1 kg-m, 15.5 lb-ft)
NOTE:
D It is recommended to use API GL-4 75W-90 gear oil.
D Whenever vehicle is hoisted for any service work other
than oil change, be sure to check for oil leakage.
Oil specification: API GL-4
For SAE classification, refer to viscosity
chart at the left.
Oil capacity: 2.2 liters (4.6/3.9 US/lmp. pt)
GEAR SHIFT CONTROL
For this item (removal, installation and adjustment), refer to same
item in SECTION 7A2.