Suzuki SY413 Service Manual page 1678

DISASSEMBLY
DRIVE SHAFT (4 A/T MODEL)
1) Remove tripod joint boot band, then take out tripod joint hous-
ing.
1. Tripod joint housing
2) Remove grease from shaft and take off circlip by using special
tool, then pull out spider from shaft.
Special Tool
(A): 09900-06107
1. Spider
2. Bearing
3. Circlip
3) Remove boot band, then pull out differential side boot from
shaft.
4) Undo band of dynamic damper, then pull out damper through
shaft.
5) Undo boot bands of wheel side joint boot, then pull out boot
through shaft.
DRIVE SHAFT (EXCEPT 4 A/T MODEL)
1) Remove tripod joint boot band, then take out tripod joint hous-
ing.
1. Tripod joint housing
CAUTION:
To prevent needle bearing of joint from being de-
greased, do not wash it if it is to be reused.
CAUTION:
D Disassembly of wheel side joint is not allowed. If
noise or damage exists in it, replace it as assembly.
D Do not disassemble tripod joint spider. If any mal-
condition is found in it, replace it as differential side
joint assembly.
FRONT DRIVE SHAFT 4A-3