7B-90 AUTOMATIC TRANSMISSION (3 A/T)
1. Transmission case
2. Straightedge
1. Differential
2. Straightedge
Case-to-bearing
clearance "d"
0.56 – 0.7 mm
(0.022 – 0.028 in.)
0.7 – 0.8 mm
(0.028 – 0.031 in.)
0.8 – 0.9 mm
(0.031 – 0.035 in.)
0.9 – 1.12 mm
(0.035 – 0.044 in.)
2) In the same manner as the above 1), measure dimension "b" of
transmission case (from mating surface to bearing bore bot-
tom).
Dimension "b" = measured value – straightedge width "e"
3) Place differential assembly on surface plate and measure di-
mension "c" (bearing-to-bearing).
Dimension "c" = measured value – straightedge width "d"
4) Obtain case-to-bearing clearance "d" in following calculation.
"d" = ("a" + "b" + 0.4) – ("c" + 0.2)
0.4 mm (0.016 in.): Gasket thickness
0.2 mm (0.008 in.): Intended to absorb the measurement er-
ror
5) Select a shim from among available sizes and install it between
transmission case and side bearing.
Available
shim size
CAUTION:
0.56 mm
(0.022 in.)
Installing of over sized shim beyond specification
0.7 mm
may cause tight rotation and consequential bearing
(0.028 in.)
damage.
0.8 mm
(0.031 in.)
0.9 mm
(0.035 in.)