Suzuki SY413 Service Manual page 1780

5-86 BRAKES
1. LSPV lever
2. Spring
3. Adjusting nut
2) Torque each bolt and nut to specification as indicated respec-
tively in figure.
Tightening Torque
(a):23 N·m (2.3 kg-m, 17.0 lb-ft)
(b):16 N·m (1.6 kg-m, 11.5 lb-ft)
3) Upon completion of installation, fill reservoir tank with specified
fluid and bleed air from brake system.
4) After bleeding air, check that LSPV is installed properly, refer-
ring to the following "AFTER-INSTALLATION INSPECTION &
ADJUSTMENT".
AFTER-INSTALLATION INSPECTION &
ADJUSTMENT
Confirm the following before inspection and adjustment.
D Fuel tank is filled with fuel fully.
D Vehicle is equipped with spare tire, tools, jack and jack handle.
D Vehicle is free from any other load.
With vehicle in above conditions;
1) Place it on level floor.
2) Push up LSPV lever with finger till it stops and measure length
of coil spring ("L" in figure) as it is pulled.
3) Spring length "L" should be the value specified below.
Spring length "L"
3 Door : 165 mm (6.5 in.)
4 Door : 160 mm (6.3 in.)
WAGON : 150 mm (5.9 in.)
4) If it isn't, adjust it to specification by changing bolt (a) tightening
positions as shown. After adjustment, tighten adjusting nut to
specified torque.
Tightening Torque:
(a): 23 N·m (2.3 kg-m, 17.0 lb-ft)
NOTE:
Check to make sure that LSPV body and brake pipe joints
are free from fluid leakage. Replace defective parts, if any.