1. Reduction driven gear nut
2. Output shaft
1. Output shaft
2. Transmission case
32) Remove reduction driven gear nut.
i) Undo caulking.
ii) Shift manual shift lever to P range so that output shaft is
locked.
iii) Loosen nut.
CAUTION:
Calmly apply torque to loosen nut so as not to
damage reduction gear or parking lock pawl.
33) Pull out reduction driven gear.
34) Drive countershaft out with a plastic hammer.
CAUTION:
To avoid unnecessary damage of speed sensor due
to contact with countershaft gear, it should be re-
moved previously.
35) Remove output shaft by pushing outer race of internal output
shaft bearing with special tools from inside of transmission
case.
CAUTION:
D Do not hit output shaft or shaft end will be dam-
aged.
D Hold special tools by hand while hitting them and
avoid their bounce.
Special Tool
(C): 09925-18011
(D): 09927-08210
AUTOMATIC TRANSMISSION (3 A/T) 7B-71