Suzuki SY413 Service Manual page 2547

9J-78 AIR BAG SYSTEM
i) Release locking of lock lever.
ii) After unlocked, disconnect connector.
1. Seat belt pretensioner connector
SEAT BELT PRETENSIONER (IF EQUIPPED)
WARNING:
D Never attempt to disassemble or repair the seat belt
pretensioner (retractor assembly). If any abnormality
is found, be sure to replace it with new one as an as-
sembly.
D Be sure to read "PRECAUTIONS" before starting to
work and observe every precaution during work. Ne-
glecting them may result in personal injury or unac-
tivation of the seat belt pretensioner when necessary.
REMOVAL
1) Disconnect negative battery cable at battery.
2) Disable air bag system. Refer to "DISABLING AIR BAG SYS-
TEM" in this section.
3) Disconnect Yellow connector for seat belt pretensioner.
4) Remove front seat belts from the vehicle in the same way as
when removing them without pretensioner described on "SEAT
BELT" in Section 9.
INSPECTION
When checking seat belt with pretensioner, use the following check
items in addition to those specified for seat belt without pretension-
er described on "SEAT BELT" in Section 9.
WARNING:
Never measure resistance of pretensioner or disas-
semble it. Otherwise, personal injury may result.
CAUTION:
If seat belt pretensioner (retractor assembly) was
dropped from a height of 91.4 cm (3 ft) or more, it should
be replaced.