Suzuki SY413 Service Manual page 1613

1. Strut bracket bolt & nut 2. Knuckle
1. Brake disc dust cover
2. Control rod
INSTALLATION
1) Install rear knuckle to strut, and connect control rods and trail-
ing rod to knuckle. At this point, temporarily tighten them by
hand.
2) Tighten strut bracket bolts and nuts to specified torque.
Tightening Torque
(a): 90 N·m (9.0 kg-m, 65.0 lb-ft)
3) Install brake disc dust cover.
Tightening Torque
(b): 10 N·m (1.0 kg-m, 7.2 lb-ft)
4) For ABS equipped vehicle, check to make sure that ABS wheel
sensor tooth is free from any metal particles and install it to
knuckle.
5) Install wheel hub referring to WHEEL HUB INSTALLATION in
this section.
6) For ABS equipped vehicle, install rear wheel speed sensor.
Refer to SECTION 5B of the Service Manual mentioned in
FOREWORD of this manual.
7) Install caliper carrier to knuckle.
Tightening Torque for caliper carrier
50 N·m (5.0 kg-m, 36.0 lb-ft)
8) Install brake disc referring to REAR BRAKE DISC INSTALLA-
TION of SECTION 5.
9) Tighten control rod outer bolts and trailing rod rear bolt to spe-
cified torque with vehicle weight on suspension.
Tightening Torque
(d): 90 N·m (9.0 kg-m, 65.0 lb-ft)
Then check toe.
10) Perform brake test (foot brake and parking brake).
11) Check each installed part for fluid leakage.
REAR SUSPENSION (2WD VEHICLE) 3E-21