Suzuki SY413 Service Manual page 2289

COMBINATION SWITCH
Combination switch incorporates lighting, turn signal, hazard warning light, dimmer, passing light and wiper/wash-
er switches and steering angle sensor.
NOTE: Terminal arrangement of combination switch coupler
viewed from harness coupler.
Inspection
1) Disconnect negative (–) cable at battery.
2) Disconnect combination switch lead wire connectors from junc-
tion/fuse box.
3) Use a circuit tester to check the continuity at each switch posi-
tion. If any continuity is not obtained, replace switch.
Removal/Installation
For removal/installation of combination switch, refer to Section 3C
or 3C1.
NOTE:
Some vehicles are not provided with INTERMITTENT position
depending on specification.
BODY ELECTRICAL SYSTEM 8-23
A. Horn switch
B. Air bag inflator (if equipped)
C. Steering sensor (if equipped)